Back to work!
The cowl is a little wider than the normal design. It is not that like original design, but it is much easier for you to replace the battery.
Main Specifications of 1200mm DIY RC Plane Balsa Kit J3 Cub:
Recommended Devices (Not included):
Radio Control: 2.4Ghz 4 channel or equivalent (click here for Radio Control)
Motor: 2212-1400kv Brushless Motor
Propeller: 9 inch propeller
ESC: 30A Brushless ESC
Servo: 9g servo x 4 pcs
Lipo Battery: 11.1V 2200mAh 20C Lipo Battery
Charger: 3s Balance Charger (Click here for charger)
Pls note that this is unaseembled plane, which comes with following parts:
All Wood Parts of the Plane (Unassembled)
1:1 Drawing of the wing
1 Set of hinges
1 Set of push rods
1 Set of clear canopy
1 set of landing gear
We will send you Photo Manual for Assembly and Attach Cover and Sticker by Email.
We offer you 7 options, pls choose from “Color Options” above according to your needs!
1. Kit without Cover (No Cover, No Motor, No Servo, No ESC, No RC, No Battery, No Charger)
2. Yellow Kit (Not include motor, ESC, servo, RC, Battery, Charger)
3. White kit (Not include motor, ESC, servo, RC, Battery, Charger)
4. Green Kit (Not include motor, ESC, servo, RC, Battery, Charger)
5. Yellow PNP (Not include RC, Battery, Charger)
6. White PNP (Not include RC, Battery, Charger)
7. Green PNP (Not include RC, Battery, Charger)
This is trainer plane Kit, you need to assemble the parts into fuselage, and wings, and finally install them!
We will do our utmost to assist you to enjoy the assembly and flying!
We also offer spare parts for our DIY balsa plane kits.
Just tell us the part no. 🙂
Part of the photo instructions:
Photos of the J-3 Cub after you assemble it: